Keraplan

Kerapoxy Epoxy-glue

Directions for use

1. Mix the two parts thoroughly in proportion 9A:1B, preferably with an electrical mixer.
2. After preparation, process the glue within 96 minutes
3. Redundant glue can be removed with a wet sponge

Warning:
Avoid contact with skin or eyes. In case of contact with the eyes, rinse immediately with water and call for medical assistance.

Sink application: Directions for use

1. Clean the edge of the sink and the underside of the worktop, using a solvent or a degreasing agent
2. Prepare the epoxy glue, as described above
3. Put the top on 3 supports
4. Spread the glue evenly on the unglazed part of the sink-edge
5. Position the sink under the top and make sure that the weight of the top rests on the glued sink-edge
6. Remove redundant glue
7. After application, rinse your hands well with water
8. Now the glue needs to dry 72 hours at a temperature above 15°C

Afb. 1

Sink apertures
If ordering a sink for a top, you need to order an aperture as well. The code-number for the aperture is the same as the code-number for the matching sink. Standard glazed apertures are indicated by adding "AV" to the code number, rebated apertures by adding "AP".

On request, sink apertures of a different size can be made.

Minimal distances of apertures for sinks VS1515, VS3015, VS1330, 42-497, 42-498, 42-501

Amin > 50 mm Bmin > 120 mm Cmin > 120 mm

Minimal distances of apertures for sinks VS3030, VS4040, VS4141, VS4545, VS5040, VS5545, VS6040

Amin > 120 mm Bmin > 120 mm Cmin > 150 mm

Rebated apertures
Special rebated apertures can be made for Steendam polypropylene drip cups. The drip cup can be fitted from above in the rebate, creating a flat surface. Three standard dimensions are available.